DIY: Film Bracelet and Earring

Almost 2 weeks ago, I was trying my new Pinhole Camera and I took some photos... too bad, I went to Walgreens to develop it.. the film was blank :( lol!

 I got a huge blank film on my hands and started made earrings and bracelets! I sent them out to my swap buddies Megan and Mary Rebecca, you can see the post HERE

The Film earrings on the left/down side of this pic :D

I decided I wanted to share this little project with my readers!!!

Two Types of Film Earrings and 1 Bracelet

So, you will need:

Heart Puncher

Blank Film

Tiny Plier (I'm kidding, any size ;))

Split Rings

Earwires

The Heart Film Bracelet♡

For this bracelet, you cut the size of your wrist and a little more for comfort- and start punching the film with your Heart Puncher - I made one up and one down. 

You can close it with sticky Velcro or 2 cuts of ribbon and just tie it down- its up to you!

Earring #1 ♡

Punch one heart, then cut do the same with the other one..make sure they are the same size.. mine is a little off!! ^^ Open the split rings and put the film and the ear wire all together! 

Earring #2 ♡

Cut the side of the film only- whatever size you want you need both sides. Open Split ring and connect the film piece both up and down and the ear wire!

That's it folks!! Really easy and super fun! ;)  I hope you like it!!


If you do any of these, I would love to see them- send photos at 


lily.juliao (at) gmail (dot) com 


If you have any questions/comments email me too!